This is often known as a “ping scan”, but you can also request that traceroute and NSE host scripts be run. This option tells Nmap not to do a port scan after host discovery, and only print out the available hosts that responded to the scan.
Here is a little quote from the man page, nmap(1): -sn (No port scan) Network ID is 192.168.3.0, just substitute the last number by 0. Here at point 2, I have the wlan0 device. Inet6 fe80::c685:8ff:fe94:ee9a/64 scope link valid_lft forever preferred_lft forever
Inet6 ::1/128 scope host valid_lft forever preferred_lft foreverĢ: wlan0: mtu 1500 qdisc mq state UP qlen 1000 Please substitute your network identifier and subnet mask.ġ: lo: mtu 65536 qdisc noqueue state UNKNOWN It’s easy to lock MAC address with IP in Linux.You can use the Nmap utility for this. So the command would be like below: iptables -A INPUT -s A.B.C.D -i eth0 -m mac ! -mac-source 1A:2B:3C:4D:5E:6F -j DROP If you still accept the incoming packets but only drop the forwarding packets, replace the INPUT with FORWARD. The command above simply means that if there is a packet from IP address A.B.C.D with the MAC address is not 1A:2B:3C:4D:5E:6F, then drop / block the connection packet. Using your favorite shell, type the command below in the command line: iptables -A INPUT -s A.B.C.D -i eth0 -m mac ! -mac-source 1A:2B:3C:4D:5E:6F -j DROP In Linux we can easily do this by using ‘iptables’ tool. That means you can block any IP address coming from different source of MAC address in Linux OS. In case you use Linux operating system as the router in your office, instead of using Mikrotik, you can do the same with Mikrotik. The goal of this task is to prevent users from changing their workstation’s IP address to break policy rules. In a previous post, we have shown you how to lock MAC address and IP in Mikrotik.
0 kommentar(er)
